Page 1 - Cleaning procedure with InSpec10 3 Roda
P. 1
Clean at least once a day to improve
cleaning efficiency, with the following:
Vikan squeegee system
Inspec N10 pre-diluted
Inspec N10 undiluted
Clean flooring at least once a day If using Inspec N10, spray the Agitate the surface with the Vikan (with warm water)
to maximise its efficiency. We surface with detergent, ensuring squeegee, until you begin to see After cleaning, wash out the equipment
advise using Inspec N10 detergent full coverage of the area. the contamination being lifted
and a Vikan squeegee system Or, use the appropriate cleaner so that it is ready for re-use.
with warm water
To remove built-up spots of contamina-
tion, clean with a 70/30 Ispropyl Alcohol
wipe.
Where decontamination or sterilisation
takes place using a phenolic or hydroxide,
rinse off as per the instructions (left).
Otherwise, a film can develop, reducing
the effectiveness of the SimStep
Do not use concentrated bleaching
agents, scouring or abrasive powders,
Begin by cleaning in a vertical Continue to agitate the surface in Remove the excess liquid or slurry or cleaning machines with stiff brushes.
direction as shown a horizontal direction as shown from the edge of the surface, and
collect with a microfibre mop or Buffing or polishing machines will
sponge system. If the removed damage the surface, shortening the
Distributor:
liquid is dirty, repeat process or
Tre Röda AB Phone: +46 (0) 70 560 63 63 increase cleaning frequency active working life of the flooring.
Tullgatan 5 e-mail: info@treroda.nu
SE-749 49 ENKÖPING – SWEDEN http: www.treroda.nu