Page 143 - 2020 U.S. Letters and Logos

GemLeaf Mounting Options
GemLeaf Laminate
1a-Plain
Price as Listed Letters with no mounting hardware, Laminated Letters can be attached to mounting surface with a combination of adhesive or double-faced tape – applied by installer – based on surface and letter weight.
2d-Combination All
ADD 10% Combination all mounts have stud through a pad on the top and bottom portion of each letter. Mounting procedure is the same as a Stud Mount. Studs can be aligned in-line for brick or block mortar upon request. Letters to stand-off the mounting surface approximately 3/8” - 1/2”. Drilling patterns are required for this installation.
2a-Stud
ADD 10%
Stud blocks are solvent bonded to letter backs to receive a stud. These blocks will require the letters to stand-off the mounting surface approximately 3/8” - 1/2”. Drilling patterns are required for this installation.
2b-Pad
ADD 10%
Pads are plastic disks on the rear of the letters. Secure the letters to the wall using a split stencil pattern or spacing tape guide and silicone adhesive. Adjustable pads available upon request. Letters to stand- off the mounting surface approximately 3/8” - 1/2”.
2c-Combination
ADD 10% Combination of studs and pads. Stud through
a pad on the top portion of each letter, pads only on the bottom portion of each letter. Mounting procedure is the same as a Stud Mount with the addition of securing pads to the mounting surface with adhesive. Studs can be aligned in-line for brick or block mortar upon request. Letters to stand-off the mounting surface approximately 3/8” - 1/2”. Drilling patterns are required for this installation.
PRICE REDUCED
Flush Stud
ADD 5%
Thicker letters (min. 3/8” thick) can be drilled and tapped for stud installation. Specify if studs need to be in line for brick / block mortar joints or rails.
Double Face Tape
ADD 10%
Double face tape mount comes with partial covered backs with a VHB, double faced tape. Full coverage email for quote. Volume of tape is based on letter size and gauge. Heavier letters may require tape and adhesive (such as epoxy on acrylic) to properly secure letters. VHB tape is designed for interior, flat, dry wall installations. Secure the letters to the wall using a stencil pattern.
Full Coverage Double Face Tape Single Piece
ADD 10%
(letters 8” and under)
Inset Double Face Tape
Call for quote Standard Clear 20 mil. Optional white or grey available.
GeminiSignProducts.com
141