Page 64 - Tattered Lace 65

3D Decoupage Blooms
WHAT YOU'LL NEED:
• 464694 3D Decoupage Blooms die set
• 464690 Stems die set
• 464702 Lace Panels die set
• White cardstock
• Complimentary backing paper
• Free Charisma download: Pressed Rose
• Red ribbon
1.
2.
Using the Lace Panels die set, cut three Lace Panel Mat 1, two from white cardstock and one from complimentary backing paper. Score one of the white die cuts 3cm from the long edge and mountain fold. Mat the white die cuts together to create a tent card. Mat the remaining die cut onto the front.
UsingtheLacePanelsdieset,
cut Lace Panel Edge 1 from complimentary backing paper and mat onto the card.
3. UsingtheLacePanelsdieset,cut Lace Panel 1 and Lace Panel Edge 1 together from white cardstock.
4. Matthelacepanelontothecard. Using the Stems die set, cut three stems and trim. Using the 3D Decoupage Blooms die set, cut each of the flowers with some corresponding decoupage pieces from the free Charisma download. Mat together using foam pads and mat the die cuts onto the card.
5. UsingtheLacePanelsdieset, cut Lace Border 1 Mat twice from white cardstock and complimentary backing paper. Cut Lace Border Edge 1 and Lace Border 1 together from white cardstock. Thread some ribbon through the lace border and secure on the back. Tie a bow from ribbon and mat into the centre. Mat the die cuts together.
6. Matthelacebordermatontothe card using foam tape.
1
2
3
4
5
6
64
www.tatteredlace.co.uk