Page 70 - Manual Nutty's 5200

Set up the printer with a computer dial-up modem
If you are using the same phone line for sending faxes and for a computer dial-up modem, follow these directions for setting up the printer.
Figure 5-6 Back view of the printer
1 2
3
To set up the 1. 2.
3.
4.
5. 6. 7.
Telephone wall jack.
Connect the phone cord to the port labelled 1-LINE on the back of the printer. You might need to connect the phone cord to your country/region adapter. Computer with modem.
printer with a computer dial-up modem
Remove the white plug from the port labeled 2-EXT on the back of the printer.
Find the phone cord that connects from the back of your computer (your computer dial-up modem) to a telephone wall jack. Disconnect the cord from the telephone wall jack and plug it into the port labeled 2-EXT on the back of the printer.
Connect one end of the phone cord to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the printer.
NOTE: You might need to connect the phone cord to your country/region adapter.
If your modem software is set to receive faxes to your computer automatically, turn off that setting.
NOTE: If you do not turn off the automatic fax reception setting in your modem software, the printer cannot receive faxes.
Turn on the Auto Answer setting.
(Optional) Change the Rings to Answer setting to the lowest setting (two rings). Run a fax test.
When the phone rings, the printer automatically answers after the number of rings you set in the Rings to Answer setting. The printer begins emitting fax reception tones to the sending fax machine and receives the fax.
If you encounter problems setting up the printer with optional equipment, contact your local service provider or vendor for further assistance.
64 Chapter 5 Fax ENWW