Page 112 - 2022-23 Auto Performance Drag Racing

Axle straps or winch straps work great for wrapping around the chassis or axle tubes when securing a vehicle to the trail- er or when winching a vehicle. Adjustable protective sleeve can be positioned as needed to help prevent strap damage from sharp edges. The working load limit is the maximum load a strap should be subjected to during normal use.
Notched Spring Cup with Removable Rubber Insert
Part No. Width Length Hook Type
Chassis Tie-Down Brackets ALL60075
Steel brackets weld to chassis and provide a secure mounting location to hook a tie- down strap or winch cable. Set of 2.
Recessed D-Ring
ALL10210
Heavy-duty recessed D-Ring.
D-Ring Backing Plate ALL60074
Backing plate strengthens and rein-
forces the mounting area of Allstar recessed D-rings. Plate may also be
used as a template when installing D-
rings and is bare steel, allowing plate to be welded in place. 1/4" thick.
Ratchet Binders
ALL10180
Secure extra equipment in the trailer with these 1" wide binders made of heavy-duty nylon webbing. Easy, one-hand operation. Ratchet binders have a 1,000 lbs. rating.
Working Load Limit
DRAG RACING
ALL10200
ALL10204 ALL10208
ALL10425
Tools & Pit Equipment
Axle Straps
Aluminum Pit Jack
Lightweight, 3,000 lb. capacity floor jack has a low profile to roll
under the lowest slung race
chassis. Made of high-
quality aluminum, jack incorporates a patented hydraulic system to reach maximum height of 17-1/2". Large, two-
piece handle has a
spring detent to lock
handle halves together. Built-in stops on
the jack prevent the handle from falling
forward past the 12 o’clock position.
Rolls easily on heavy-duty rear caster wheels. Optional dirt wing adapts jack for use in unpaved pits.
Part No. Description
Dirt Wing for Pit Jack
ALL10426
Provides a sturdy base when using the pit jack on a dirt surface.
Jack Stands ALL10124
Jack stands with unitized frame will support three tons. The ratchet locking mechanism assures safe, positive height control. Adjustable from 12-1/2" to 17-1/2". Sold in pairs.
Stack Stands ALL10254
Support stands can be
stacked together to
conserve valuable space
in the trailer or shop.
Stands are 14" tall with
a sturdy 12" x 15" base and rated at 3,000 lbs. each. Sold in pairs.
Part No. Description
ALL10200
2"
24"-40" Adj.
Twist
1,660 lbs.
ALL10203
2"
21"
Delta Ring
3,300 lbs.
ALL10204
2"
21"
D-Ring
1,660 lbs.
ALL10207
2"
33"
Delta Ring
3,300 lbs.
ALL10208
2"
33"
D-Ring
1,660 lbs.
ALL10422
3-Pump, Red
ALL10425
6-Pump, Silver
ALL10254
Steel
ALL10255
Aluminum
ALL10182
Stack Stand Pads ALL10256
NEW!
Part No.
Description
Steel-reinforced rubber pads
bolt to the top of our Stack Stands
to help eliminate vehicle movement
when located on stands. Pads measure
8-1/2" wide and include two molded-in studs with hardware for easy installation. Drilling is required to Stack Stands for installation. Sold in pairs.
ALL10180
Standard 8' Length
ALL10182
Heavy-Duty 16' Length
110
2022-23