Page 16 - 2014E-TypeSupplement

Under-Car Hard Parts From The Leader

Inner Fulcrum Shaft Rebuild Kits

These kits include everything required to rebuild the inner fulcrum shafts: C17165 outer
thrust washers, C17166 Inner thrust washers, C17167 needle bearings, C17168 or

C17168-1 bearing tubes, C17213 sealing rings, C17936 retainers and C8667/5 nuts.
Two kits required per car. Buy the kit and save ten percent!

3.8 E-Type to OTS 879131 & FHC 888326 13-1550

Later 3.8 E-Type plus all other IRS Cars
13-1552

Kits include all hardware.
Thrust washers, needle bearings,
seals, and retaining nuts. Order
two kits for whole car.

I.R.S. Needle Bearing

Now made by XKs Unlimited. For the inner I.R.S.
fulcrum shafts. Eight required per car.
F
our pieces shown

Order Number, Each CO-17167

Special Transmission
Support
Suspension
Spring
Bolt
For V-12 with manual
Tie rod lever to stub axle
carrier for Series II.
transmission.

Order Number CO-30250
Order Number
CO-12299

Differential Housing Shims

Most Earlier IRS Diferentials.
.003” Shim, each 13-9754

.005” Shim, each 13-9755
.030” Shim, each
13-9757

I.R.S. Hub Components

Seating Ring. For inner oil seal, I.R.S. hub carrier.

Order Number JA-CCC6807

Oil Seal Container. On the outer fulcrum shafts, I.R.S. cars.
Four required per car.

Order Number CO-20179

JA-CCC6807
Retaining Washer. On seating ring for oil seal.

Four required per car.

CO-20179
Order Number CO-20182

Outer Hub Carrier Fulcrum Bearing. Now made
by XKs Unlimited. For the outer hub carrier ful-

CO-20182
crum shafts. Four required per car.
Order Number CO-16029
CO-160
29

16 New Parts Supplement
www.xks.com