Page 10 - Winter 2017 Coventry Quarterly

1⁄

E-Type Parts Series I • I2 • II • III

NEW Early 3.8
New 4.2
Dynamo Mount
Alternator
Bracket
This is a brand new As tted to 3.8 E-Type Engine
reproduction of the Lucas
R.1001 to R.1509. Made in England.
23526 alternator as tted
$79.95
CO-14917
to 4.2 Series I and “Early A/C”
Series II cars. Sold outright

with no core charge.
NEW Upgraded Ignition
$176.00
Condenser
CO-25073
For all six-cylinder E-Type. While more

Distributor Base Plate Assembly
expensive, these are far superior to recently
After almost 50 years in service and positioned right below available parts. For the full story, see page 19.

the sometimes leaking thermostat housing,
LU-DCB101
$13.95
original E-Type distributor base plates

are nearing the end of their service

life. (Or arrived long ago.) These
new plates correct those issues
NEW Adjustable

and are superior to others on the
Stromberg Carburetor
market because they are actually Jet

assembled correctly and can rotate Stromberg carburetors with xed
freely to obtain proper vacuum
needles o er virtually no mixture
advance. Supplied with terminal lead and hardware. For 22D6 adjustment. This new item replaces the
distributors tted to later 3.8 and all 4.2. (22D6 distributors have
standard jet at the bottom of the car-
points secured by a single screw -- as opposed to two on earlier buretor and allows mixture adjustment
distributors.)
where none existed before. Sold per
$44.95
each. Beautifully made in the USA.
LU-422318
$85.00
NEW V-12 Jack Shaft Bearing Kit
03-B20174ADJ

Discontinued by Jaguar, a V-12 engine rebuild would
be incomplete without these bearings. Luckily, an

engine builder friend in England now
makes a top-quality kit of three

bearings.
NEW Brake
$225.00
01-0250 Ratchet and

Pawl Assembly
For LWB

Shift I.D. Plate, V-12
These case-hardened
pieces t Series I and II
Replace a cracked or faded original.
$37.12
2+2 plus all V-12. Made in England.
BD-38409 $132.00
06-2005

For E-Type Mechanics Everywhere

Many E-Type mechanics use the heater box as a tool and parts tray. This isn’t good for

the top of the heater box and it’s even worse if those small parts
roll o into some under-bonnet nether region. Our tray

is made from the same nearly indestructible vinyl that
long-haul truckers use to tarp their loads. A layer of

soft foam protects the heater box and a large lip con-
tains tools and parts. Magnets keep the tray in place.

Made for you in the XKs Unlimited Trim Shop.

Series I and II 17-4400 $44.95

Series III V-12 17-4401 $44.95

10
Winter 2017
www.xks.com 1-805-544-7864
800-444-5247 www.xks.com