Page 88 - McWane Poles Sales Manual 2024
P. 88
88
McWane Poles, A Division of McWane Inc.
Part 1 - General
1.1 Related Documents
A. None
1.2 Summary
A. This document summarizes the requirements for ductile iron poles. Ductile iron poles shall be
clean shaft, direct embed poles. Hardware shall be attached using through bolts, tapped holes, or
threaded rivet nuts installed in the pole wall.
1.3 Indentification
A. Part Number Logic:
SPECIFICATIONS
B. Poles will be identified by information engraved on a stainless steel nameplate and written on the
pole baseplate. The nameplate shall be centered 5’ – 0” above ground line on the 0° or “B” axis.
The nameplate shall contain the following information:
Serial Number
Structure Number
Pole Height
Pole Class
Nominal Weight
Manufacturing Date
Customer
Capacity
The baseplate shall be marked with permanent marking with the following information:
Drawing Number
Structure Number (if requested)
Pole Height and Class
Actual Weight
C. Two Piece poles shall have a second nameplate centered 0’ – 4” from the tip of the pole on the 0°
or “B” axis.