Page 4 - Mini-MDR Lite

1 2 Transportation Storage and and Handling
The Rheoline Mini-MDR Lite is to be transported in in in the upright position and it it must not be exposed to any heavy shocks such as dropping it it or placing it it by liquids or or or or corrosive chemicals For long periods of storage
or or or transport all bare metal parts should be corrosion protected 1 3 Installation
Check that all items on the packing list are included in in in your shipment and immediately report any discrepancies or or damage to Prescott Instruments Ltd or any third party acting on behalf of Prescott Instruments Ltd To prevent damage to the machine or personal injury installation and commissioning should only be performed by trained personnel 1 1 3 1 1 Machine Positioning
It is is recommended that the machine is is positioned on on a a a bench or or work surface approx 75cm (30inches) high and able to hold the the weight of the the machine and sample cutter
if supplied It is is advisable to locate the machine in in a a a a a a clean area if possible and a a a a a temperature controlled room would be advantageous (10 to to 30° C ambient temperature 10% to to 85% relative humidity non condensing) You will also need a a a single phase electrical supply and compressed air services on hand The machine should be levelled once in in position by adjusting the the the four feet at the the the bottom by screwing them in or or out of the floor plate 1 3 2 Connecting ‘Services’
Connect the the mains power lead to the the machine (see page 8) and then connect the the the other end to local power supply plug type depends on on Country and region Fix the the filter regulator unit (air) supplied with machine to to the the wall in in close proximity to the the machine position and feed the the air into the the the the inlet port of the the the the unit and then connect the the the the outlet port port to the the the “air in” port port of the the the Mini-MDR Lite Screw the the the push- fit exhaust exhaust muffler (supplied) into the port marked “exhaust” (see page 8 ) Once complete turn the compressed air onto the machine and set regulator pressure to to 60psi / / 4 Bar / / 4MPa Connect the the communication lead to the the Mini-MDR Lite comm port situated on the the lower back of the the machine (see page 8) if you require the instrument to be networked 1 3 3 3 3 Powering ‘ON’
When every thing is connected you can power the Mini- MDR Lite machine ON the ‘power on’ switch is located Back of the the Mini-MDR Lite The internal light will come on in in in the the machine cabinet when the power is applied 4 RHEO-LINE MINI-MDR LITE SERVICE MANUAL © PRESCOTT INSTRUMENTS LTD © PRESCOTT INSTRUMENTS LTD RHEO-LINE MINI-MDR LITE SERVICE MANUAL