Page 102 - U.S. Harris 8/27/19

PLASTIC LETTERS / LASER CUT ACRYLIC
Flat Cut Acrylic Mounting Options
Threaded Stud
Adjustable Pad
2d-Combination All
ADD 5%
Combination all mounts have stud through a pad on the top and bottom portion of each letter. Mounting procedure is the same as
a Stud Mount. Studs can
be aligned in-line for brick
/ block mortar or rail upon request. Drilling patterns are required for this installation.
1a-Plain
Price as Listed
Letters with no mounting hardware.
Threaded Stud
Threaded Stud Block
2a-Stud
ADD 5%
Stud blocks are solvent bonded to letter backs to receive stud. These blocks will require the letters to stand-off the mounting surface approximately 3/8”
- 1/2”. Studs can be aligned in-line for brick / block mortar or rail upon request. Drilling patterns are required for this installation.
Fixed Pad
Pads are plastic disks on the rear of the letters. Secure the letters to the wall using a split stencil pattern or spacing tape guide and silicone adhesive. Adjustable pads available upon request. Stencil pattern recommeded.
Threaded Stud
Adjustable Pad
Fixed Pad
2c-Combination
ADD 5%
Combination of studs and pads. Stud through a pad
on the top portion of each letter, pads only on the bottom portion of each letter. Mounting procedure is the same as a Stud Mount with the addition of securing pads to the mounting surface
with adhesive. Studs can
be aligned in-line for brick
/ block mortar or rail upon request. Drilling patterns are required for this installation.
2b-Pad
ADD 5%
Double Face Tape
ADD 5%
For interiror, flat, smooth walls only. Double face tape mount comes with partial covered backs with a VHB, double faced tape. Volume of tape is based on letter size and gauge. Heavier letters may require tape and adhesive (such as epoxy on acrylic) to properly secure letters. VHB tape is designed for interior, flat, dry wall installations.
Flush Stud
ADD 15%
Installation tips
Installation videos available at:
GeminiSignProducts.com > Resources >Installation & Maintenance
Installation PDFs available at:
GeminiSignProducts.com > Letters & Logos > Laser Cut Acrylic > Installation
Letters 3/8”-1-1/2” thick can be drilled and tapped for a FLUSH STUD installation. Studs can be aligned in-line for brick/block mortar joints, or rail, upon request. Drilling pattern are required for this installation.
Size Limits of Double Face Tape by Thickness of Acrylic
1/8” 3/16” 1/4” 3/8” 1/2” 3/4” 1” 1-1/2”
22”x22” 22”x22” 20”x20” 16”x16” 14”x14” 12”x12” 10”x10” 10”x10”
100
INSTALL GUIDES PRICING NOTES
• Drill Patterns/Stencil Guides:
1-10 characters = $41.65 11-20 characters = $83.30 21-50 characters = $133.30 51+ characters = $249.98
• Cut file available - $41.65 (no stud locations)
• All install guide options - see page 242
259
• Lower case letters, where available, are 75% of upper case price
• Small punctuation such as period, comma & dash are 33% of upper case price
• Standard paint color add 30%
• Custom paint color add $20/color +30% (specialty paints may be additional)
1.800.538.8377