Page 34 - Roberston & Sinclair Catalogue

Shank Type Tools
Solid Carbide Spirals
Series 1800/1900
Three Flute Finishing Spiral
Finishing tools are used when an extremely smooth edge is required. The three flute design provides a better finish than the two flute at the same feed rate. Three flute tools are used for cutting natural woods and man-made wood composites. Some users experience greater tool life compared to a two flute tool.
D L2 d L1 UPCUT PART NO. DOWNCUT PART NO.
WOOD COMPOSITES
6.4 19 6.4 64 VOR1830 VOR1930
6.4 19 6.4 64 -- VOR1930L
9.5 32 9.5 76 VOR1840 VOR1940
9.5 32 9.5 76 VOR1840L VOR1940L
12.7 32 12.7 76 VOR1850 VOR1950
12.7 32 12.7 76 -- VOR1950L
12.7 44.5 12.7 89 VOR1860 12.7 44.5 12.7 89 VOR1860L 12.7 54 12.7 101.6 VOR1865
16 54 16 101 VOR1870
VOR1960 VOR1960L VOR1965
VOR1970
16 54 6 101 19.1 63.5 19.1 127 19.5 63.5 19.5 127
19 41.3 19 101 19 89 19 152 19 89 19 152
-- VOR1880
VOR1880L
VOR1882 VOR1885*
--
VOR1970L VOR1980
VOR1980L
VOR1982 VOR1985* VOR1985L*
HARDWOODS / PLYWOOD
Series 2000/2100
Three Flute Chipbreaker Spirals
HARDWOODS / PLYWOOD
Chipbreaker cutting edges “break” the chips into smaller pieces reducing power
consumption and vibration. Chipbreakers are staggered on each flute to produce a
smooth edge cut, but may leave visual lines when used with router spindles in poor
Solid Tungsten Carbide
MEC
D L2
condition. Chipbreaker tools are recommended for hardwoods, plywoods and dense materials.
d L1 UPCUT PART NO. DOWNCUT PART NO.
9.5 32 9.5 75 VOR2040 VOR2140
9.5 32 9.5 75 -- VOR2140L
12.7 31.8 12.7 76 VOR2050 VOR2150 12.7 44.5 12.7 89 VOR2060 VOR2160
12.7 44.5 12.7 89 12.7 54 12.7 101.6 15.9 54 15.9 101 15.9 54 15.9 101 19 64 19 12.7
VOR2060L VOR2065 VOR2070 VOR2070L VOR2080
-- VOR2165
VOR2170 -- VOR2180
KEY OD = Cutting Edge Diameter L2 = Cutting Edge Length (mm) Od = Shank Diameter (mm) L1 = Overall Length (mm)
All care has been taken to ensure information in this catalogue is accurate. However we reserve the right to make corrections without notification.
2-6