Page 215 - Gas Detection Systems Training Manual
P. 215
To perform a lamp test to either determine the location of a remotely installed 3100 or insure that the LEDs on a given 3100 are working, press the “Lamp Test” button from the Manual Control Panel- There will be a slight delay of up to 5 seconds before it may begin:
The button changes from blue to green and the text changes from “Off” to “On”. It will remain this way until it is turned off. While this screen is displayed, all LED and 3100 relay states for the given device are controlled as seen in this panel- this panel represents the actual states of these relays and LEDs.
As shown above, all relay coils are off. They can individually be turned on and off, including all functions on or all functions off, or in groups, such as all relays on as shown below:
Once you leave the Manual Control Screen, all states are returned back where they are supposed to be according to the device. Ideally it is best to turn all functions off:
Sensor Electronics Corporation 5500 Lincoln Drive Minneapolis, Minnesota 55436 September 29th, 2006
Page 31 of 66
952-938-9486
SEC 3500 OI Supervisor Operator’s Manual Version 2.1.0095
