Page 229 - Gas Detection Systems Training Manual
P. 229
As shown above, a popup appears in the middle of the display indicating that the coil has not yet been assigned. You can assign this coil by pressing the “Modify Assignment” button, as previously discussed. But more specifically regarding coil forcing, even though it is not assigned, you can still force the coil on or off as indicating in the popup box. The behavior is identical to that previously described for forcing coils.
If in the process of assigning a coil or at any other time, you decide you do not want a particular coil assigned anymore, you may un-assign it by navigating from the Device Summary screen for the associated Relay Module, choose the coil, select the “Modify Assignment” button on the Relay Assignment screen as shown above, and then press the “Un-Assign” button as show below on the Assign Relay Coil Screen shown below:
Sensor Electronics Corporation 5500 Lincoln Drive Minneapolis, Minnesota 55436 September 29th, 2006
Page 45 of 66
952-938-9486
SEC 3500 OI Supervisor Operator’s Manual Version 2.1.0095
