Page 233 - Gas Detection Systems Training Manual

Press the “Supervisor Menu” then “Main Menu” buttons or the Main Menu Key to launch the Main Menu.
8.2 Manually Discovering Devices
There are various reasons for manually discovering devices on the RS485 Modbus. It may be a new setup, or a newly added device, or even a replaced device. If you have not configured the HMI for Auto-Discovery (factory default state), this would then be required, or if you simply want to bring the device up immediately before waiting for Auto-Discovery, then performing this operation manually make sense.
Once logged in as the Supervisor, launch the Main Menu by pressing either the menu key on the bottom-left-hand corner of the HMI, or by pressing the SEC Logo icon on the bottom-right corner of the screen. Choose the “Screen Selection” option from the Main Menu (as depicted on the following page):
Sensor Electronics Corporation 5500 Lincoln Drive Minneapolis, Minnesota 55436 September 29th, 2006
Page 49 of 66
952-938-9486
SEC 3500 OI Supervisor Operator’s Manual Version 2.1.0095