Page 244 - Gas Detection Systems Training Manual

8.3.5.1.1 Change IP Address Screen
The Ethernet IP address and other related network parameters can be set as shown above, for your specific factory or management network if you intend to have network access to your SEC 3500 OI HMI panels. If you do, you can take advantage of the built in WEB server that allows viewing of real-time summary statistics, data trending (when it is added), other future WEB pages, as well as remote access and control of the HMI through a WEB browser. Additionally, there are future possible connectivity options over the Ethernet port such as OPC, Modbus Ethernet/IP, and many others.
The HMI’s MAC address is displayed in the top-left panel- this cannot be changed but can be used for adding this panel as a trusted device in a secured domain- this address uniquely identifies each individual panel on the network. The top-right panel allows entry of the assigned static IP address, obtained from your network administrator. The lower- left panel allows entry of your subnet mask, and the bottom-right panel allows you to enter your gateway IP address- both obtained from your network administrator.
Once you are done making your changes, you MUST press “Save Changes” for them to take effect- the panel will be rebooted automatically once you press “Save Changes” and the IP settings will not go into effect until the panel is rebooted and up and running. It is important to power-cycle the unit after it is rebooted to be certain that the IP settings are truly set and functioning as intended.
Sensor Electronics Corporation 5500 Lincoln Drive Minneapolis, Minnesota 55436 September 29th, 2006
Page 60 of 66
952-938-9486
SEC 3500 OI Supervisor Operator’s Manual Version 2.1.0095