Page 388 - Gas Detection Systems Training Manual

start on page 46 and end on 49. The default username is super and the default password is also super (this can be changed later, follow page 56 for this in the manual).
6) Once the supervisor has logged in, press the “Supervisor Menu” button.
7) This will bring up a list of buttons to press, press the “Configuration” button at the top.
8) Another list of buttons will show and click the “IP Address” button at the top.
9) Now a screen will appear with four boxes. The only two we will worry about currently
are the two on the right, “IP Address:” and “Gateway Address:” See figure 2 for this screen.
Figure 2 – IP Address Menu
10) Click on the “Gateway Address:” button and enter the gateway address you got from the network administrator. Note: You may need to click on the first three numbers in the “Gateway Address:” box to highlight the numbers. Then click on them again to bring up the menu to start entering the address.
11) Start by typing in the first three digits, the press the next button, do this until the address has been entered.
12) An example address would be 192.168.1.1. When entering this in, first enter in the 192 and click next, then enter 168 and click next, then enter one and click next, and finally enter 1 again and click enter. The ending address should like as follows: 192.168.001.001.
IP address box, make sure this is unique if more than one 3500 is on the same network
Place to enter default gateway address received from network administrator