Page 337 - 2021-22 Auto Performance_Hot Rod and Early Muscle
P. 337
PWI30100
Kit is ideal for use with high-am-
perage fans or in dual cooling fan
applications. 70-amp relay protects
the electrical system from voltage spikes and prevents the fan from feeding back through the system.
DuraSpark II Harness
PWI30812
Easily convert Ford points ignitions
to DuraSpark II electronic system with this
harness. Requires DuraSpark II distributor and yellow or blue ignition module.
Universal Fuel Pump Relay
PWI50102
A relay will prevent voltage drops
at the electric fuel pump to maintain
constant pressure and prevent amperage overloads from damaging the electrical system. It's a good idea to relay fuel pump for the street or in racing situations.
30-Amp Single-Pole/Single-Throw Relay
PWI80130
Replacement relay for use with CirKit boss, horn relay, or fan relay kits.
Relay Base Port
PWI80133
The same high-impact ABS plastic relay base used on all Painless products. Terminals are provided.
LED No-Load Flasher
PWI80230
LED bulbs do not draw enough power to
solves this problem, and turn signals oper- ate as expected.
Remote Master Disconnect Switch
PWI30204
Kit uses a small toggle switch to activate a 250- amp continuous-duty solenoid. It can also be easily hidden for security purposes. Sole-
noid mounts anywhere along the positive battery cable run. Kit includes toggle, so- lenoid, wiring, switch fuse, battery cable terminals, and mounting hardware.
Delco Alternator Pigtail
PWI30706
A replacement pigtail with original plug for the DelcoTron alternator. It's pre-terminated with an ignition input wire and the voltage sensing wire.
(140-190 amps)
PWI30700
In most cases, your fac-
tory wiring or even a Painless
Performance chassis harness
is only rated for an alternator
with 80 amps or less. Connecting your new high amper- age alternator using too small a charge wire will lead to inadequate charging and/or over heating of the charge Alternator Kit will let you safely, reliably, and “Painless- ly” install an alternator with up to 190 charging Amps. The kit includes a high amp inline fuse with protected fuse holder, all necessary ring terminals, heat shrink, and a detailed set of diagrams and step by step instructions to provide a professional installation.
High AMP Alternator Shutdown Relay
PWI50105
This kit has a 250-amp solenoid and
will handle alternator feedback from
the highest amperage alternators. Eliminates engine run-on when the
master disconnect is turned off. Easy
to install with all hardware and instructions.
“CS” Style GM Alternator Pigtail
PWI30707
Pigtail has the original factory plug for late-style or “CS” GM alternators. A resistor is included.
Ceramic Voltage Reducer
PWI40027
If an engine with 12-volt starter and
ignition has been swapped into a
car with a 6-volt system, the voltage
reducer will allow accessories like the
original heater and radio to be retained. The reducer carries a 4-amp maximum current, but can be run in parallel to increase load capacity. Will not work with gauges.
PWI30702
Kit includes GM door switch- es, wires, and light sockets to install courtesy lights inside the vehicle.
PWI30710
Kit Includes wires and light sockets to install courtesy lights inside your vehicle.
2021 HOT ROD AND EARLY MUSCLE
335
