Page 20 - US Catalog May 2024_V3 PRINT

GROUP LOCKOUT - THE GROUP LOCKBOX METHOD
According to the OSHA 1910.147 Standard, when servicing or maintenance is performed by a crew or group, employers must use a procedure that provides employees with a level of protection equivalent to the implementation of a personal lockout or tagout device. To accomplish this, personal lockout padlocks can be attached to a group lockout device, such as a Hasp or Group Lockbox.
When there are many energy sources, or many employees, the Hasp Method of Group Lockout can become overly complex and expensive.
The Group Lockbox Method is perfect for when there is:
• 5 or more isolation points
• Each employee has 1 or 2 personal locks from employer
• Large number of employees involved in group lockout operation
• When employees will be joining and leaving the lockout frequently(shift change, etc.)
1. Before Isolation begins all affected persons must be notified that the machinery is being shut down and locked out.
2. The employee in charge of the isolation (Known as the Isolation Owner) must isolate, Lockout, Tagout and Try-out every piece of machinery involved in the servicing or maintenance job.
3. The isolation owner must then place all the keys used in locking out all the machinery into the Group Lockbox.
4. The isolation owner must then close the lockbox and lock their personal padlock onto the box.
5. All other employees involved in performing the service will inspect the lockout and then lock their personal padlock onto the lockbox. If the employee leaves; they may take their padlock off, however it is important to note that the isolation owner never takes their padlock off until everyone else has left the isolation procedure.
6. Any other employees that join the lockout will lock their padlock before performing the service.
1. When the work has been completed, and all employees have left the machinery, taking their personal padlocks off the lockbox, the isolation owner can then (And only then!) take their personal padlock off the lockbox and open the lockbox up.
2. All the keys can be taken out the lockbox.
3. The isolation owner can then take all the locks off the isolation points, and the machinery is ready for re-energizing.
4. All affected persons can now be notified that the machinery is back up and running as normal.
• If your site is remote, store all equipment needed in a portable lockbox – To make isolations as simple as possible for the isolation owner, all the equipment needed for the isolation can be stored in a portable lockbox, such as the RGL12. The RGL12’s latch has been reinforced for this purpose
• Use Keyed Alike padlocks for the isolation points – Using keyed alike padlocks for the machine isolation means that when it comes to taking the padlocks off, the isolation owner doesn’t have to carry multiple different keys
• Still use Hasps – Seems a strange suggestion, but hasps, such as the MLH1 can be used to extend the maximum users of a lockbox, for contractor teams joining the lockout procedure, or even if isolation ownership needs to change on the isolation point itself
The Group Lockbox Method
The Group Lockbox Method: The steps to locking out
The Group Lockbox Method: The steps to re-energizing the machinery
The Group Lockbox Method: Top Tips from Experts...
GROUP LOCKOUT - THE GROUP LOCKBOX METHOD
20