Page 232 - IE.IE Limited - Sealey Tools Catalogue

232
Car Ramps & Axle Stands
B
A
2000kg
A Car Ramps
1tonne per Ramp 2tonne per Pair Model No. CAR2000
Manufactured from 3.5mm steel section. Suitable for professional or serious DIY applications. Corrosion resistant finish. Ramps stack together and will stand upright for easy storage.
B Car Ramp Extensions
400kg per Ramp 800kg per Pair Model No. CAR2001
Steel construction car ramp extensions to decrease ascent angle. Ideal for sports cars and vehicles with low ground clearance. Attaches to standard car ramps with a minimum width of 195mm. Suitable for use with Model No. CAR2000.
Capacity (Each/per Pair): 400/800kg Length: 630mm
Capacity per Pair: Length:
Ramp Height: Maximum Height: Maximum Width: Maximum Tyre Width:
2000kg 800mm 190mm 250mm 345mm 200mm
Maximum Width:
195mm
CORRECT
CORRECT
CORRECT
INCORRECT
INCORRECT
INCORRECT
Sold in pairs.
C - D Folding Yankee Axle Stands Model No. SEE BELOW
Folding design saves space and makes these axle stands ideal for occasional use. Constructed entirely from steel. Folds down for ease of storage. Fitted with locking safety pin. Sold in pairs.
E - H Yankee Axle Stands Model No. SEE BELOW
Sold in pairs.
VEHICLE SUPPORT & AXLE STANDS IMPORTANT SAFETY WARNING!
WHEN JACKING A VEHICLE ALWAYS USE AXLE STANDS AND CHOCKS. NEVER GET UNDER A VEHICLE SUPPORTED ONLY BY A JACK.
1. Axle stands and High Level Vehicle Supports are capacity rated individually. Axle stands are sold in pairs and High Level Vehicle Supports are sold singly. A pair will normally support double the rated single load but be aware - you may know the total weight of the load you are supporting, but you cannot be sure that the load weight is spread evenly across both stands. For this reason always use higher capacity stands than you think you need.
2. Axle stands and vehicle supports are designed to support a static load in the middle of the engagement head (crutch). Take care to load evenly and never on the edge of the engagement head. Always take steps to ensure the load cannot move, use wheel chocks (see page 231 in this catalogue), apply vehicle brake and put in gear or "park".
3. All the axle stands and supports in this catalogue are designed for professional use and tested to ensure they meet or exceed International Standards.
D
F
H
C
SAFETY FIRST
Visit our website and watch our 'How to use' Axle
Stands Safety video. Your personal safety is important when working under a vehicle and we suggest you watch the video and read the instruction manual prior to use.
E
G
Ratchet type axle stands, with cast iron support posts.
release of load - the more weight applied, the tighter the post is locked. Sold in pairs.
Features angled teeth in posts, which prevent accidental
CDEFGH
Model No:
Capacity Each:
Capacity Pair:
Minimum Working Height: Maximum Working Height:
AS2000F
2tonne 4tonne 275mm 360mm
AS3000F
3tonne 6tonne 285mm 405mm
Model No:
Capacity Each:
Capacity Pair:
Minimum Working Height: Maximum Working Height:
VS2002
2tonne 4tonne 265mm 415mm
VS2003
3tonne 6tonne 275mm 400mm
VS2006
6tonne 12tonne 395mm 615mm
VS2012
12tonne 24tonne 430mm 675mm
sealey tools
@sealeytools
sealey tools
www.sealey.co.uk