Page 456 - IE.IE Limited - Sealey Tools Catalogue

A-B AC/DC Current Clamps
A
B
C
NEW
456
Automotive Current & Relay Testers
Model No. SEE BELOW
Designed for use with a standard multimeter and measures current draw from vehicle components in situ. Suitable for measuring both AC and DC current, without breaking into the circuit. Fitted with 4mm banana connectors and supplied in storage pouch. Powered by 9V battery (supplied). Can also be used with an oscilloscope using a suitable BNC conversion adaptor.
C Fuse Current Tester 50A Model No. TA113
Easy-to-use hand-held automotive current measuring tool. Revolutionary new method now makes it possible to determine the amount of current in a fused circuit, without removing the fuse. Troubleshoots parasitic drain problems and identifies active/inactive circuits via the fuse box. Suitable for 6, 12 and 24V systems. Powered by 3 x AA batteries (supplied).
Maximum Current: 50A Current Range: 5mA–50A Maximum Voltage: 24V Accuracy: ±5%
Model No: A TA310 B TA311
Clamp Size Ø:
Current:
20A(AC), 80A(DC) 40A(AC), 400A(DC)
Relay Circuit Diagnostic Tester Model No. TA130
Fast, accurate and safe relay circuit tester that tests the supply, earth and trigger wires within the automotive circuit. Simply remove the relay and install the corresponding dummy relay. Includes a universal fly lead for non-standard relay pin configurations. Earth, supply and trigger terminals are displayed as green or red LEDs. The tester can also be used to power components by simulating the relay in the on/off positions using the test button. Dummy Relays: 7 Including
1 Universal Fly Lead
12mm 28mm
D
D
E
Relay Configurations:
4, 5 Pin
D
E Relay Tester Model No. TA131
Health test for 4 and 5 pin electro-mechanical relays commonly found on modern vehicles. Test feature will cycle the relay ten times, testing the resistance, contacts and consistency within each cycle. If a cycle fails on the test then this will be indicated by a red LED and alternatively a green LED if relay works.
F
G
Relay Configurations:
4, 5 Pin
H
F Noid Light/IAC Test Set 11pc Model No. VS2131
Locate and isolate ECU signal faults fast. Noid and idle air control valve indicator lights test for control signal from ECU. Simply disconnect harness and plug in appropriate light to see if the component is being fed a trigger signal. Set includes 1.3mtr fibre optic cable to allow light to be viewed from the driver’s seat. Simple to use and has a wide vehicle application.
Noid Light Applications: GM TBI, GM SCPI, GM FPI, GM MULTEC 2, Bosch 2, Bosch PFI, Ford TBI, GEO TBI IAC Light Applications: GM 700 TBI/FPI with flat or
square 4-pin connectors
G
Noid Light Set 6pc
Model No. VS213
Check fuel injector signal faults fast. Simply disconnect injector harness and plug in noid light. Turn the ignition on - if the light is steady or absent, then signal from ignition system is at fault. Easy-to-use and fits a wide variety of injector harnesses.
Applications: GM PFI, Ford TBI, GEO TBI, Bosch PFI, GM TBI, GM SCPI
H Relay Pliers Model No. VS224
Designed for the safe removal and installation of relays commonly found on modern vehicles.
sealey tools
@sealeytools
sealey tools
www.sealey.co.uk
6V to 24V