Page 758 - Icon Ridge Automotive & Truck Catalog (1)

Vehicle products

The Perfect Tyre-Repair - Operation Instruction

Repairable zone:
Tread, the following table applies:
Vehicle type Vehicle Vehicle Truck/ C-Tyres Truck / AS / EM Motorcycle
Tyre type: up to 210 km/h up to 270 km/h and tyres with LI Tyres with LI of 123 up to 270 km/h
even Run-Flat-Tyres even Run-Flat-Tyres up to 122 and more
Tread damage: max. 6 mm max. 3 – 4 mm max. 6 mm max. 10 mm 2 – 3 grafts max. 3 – 4 mm
for each repair
Art.-No. 6470 4701 ● ●
Art.-No. 6470 4702 ● ●
Art.-No. 6470 4711 ● ●

1 Dismantle the tyre. Remove the object that caused the hole. Check 5 Pull the repair stick into the induction awl up through the centre.
the damaged spread. May not exceed up to back tyres (210 km/h) In case of repair sticks for front tyres, remove the red film
6 mm and 3 mm in front tyres (270 km/h) beforehand.Attention!
2 Clean the inner surface to a diameter of approx. 30 mm around the Prevent any impurity of the repair stick
damaged spot with 1K-ASK-Cleaner.
6 Apply a bit of rubber solution to the top of the induction awl.
3 Clean the hole duct with a square pricking awl.
4 Apply 1-2 drops of rubber solution the the eyelet of the induction
awl and insert it into the hole duct. Repeat this process 3 or 4
times.

7 Press the induction awl with the repiar stick into the hole until 8 Slowly pull out the insert awl and cutt off the overlapping edges
10 mm ofth repiar stick is visable. Then turn it 90° under pressure. of the repair stick aprrox. 3 mm above the profile.

9 Apply approx. 3 cm of the repair fluid plaster around the repair stick 10 Tyre can immediately be mounted.
from the inside.

Technical data subject to change.
Availability subject to country specific rules and regulations. www.iconridge.com Source: Theo Förch GmbH & Co. KG 758