Page 131 - Industrial Tools Catalog (1)

Reaming tools \ Technical introduction – reaming

The basics of reaming

reaming is part of the precision machining process or finishing process. holes are mainly reamed in case of
special requirements around surface quality, roundness, cylindricity and diameter tolerance.
set the hole with a particular allowance, see allowance table, then create the desired fit with the reamer.

Note: if not necessary, do not countersink hole due to the negative impact on the service life of the reamer.

Surfaces that can be achieved compared with other procedures

Average surface finish Ra 25 12,5 6,3 3,2 1,6 0,8 0,4 0,2 0,1 0,05 0,025
average roughness Rz 100 63 40 25 16 10 6,3 4 2,5 1,6 1 0,63 0,25
Drilling

Drilling out

Spindles

Grinding

Sanding

Honing

Rolling

Producible Conditionally producible

Source: Hahn+Kolb Werkzeuge GmbH
Technical data subject to change. www.iconridge.com 131
Availability subject to country specific rules and regulations.