Page 732 - Industrial Tools Catalog (1)
P. 732
Tool clamping \ Tool extension with straight shank
VIDAT extension for screw-in mill cutter (screw-on mill cutter)
vibration-damped
< – 0,01
Execution: Advantage:
the damping element of the extension is in close proximity to the tool interface reduction of vibrations in the clamping system
because that is where the highest degree of bending occurs vibration-damping effect minimises micro ruptures and improves the surface
maximum permitted rotation speed 8000 rpm. quality of the tool
max. concentricity < 0.01mm increase of tool service life
drilled for internal coolant supply (ICS) up to a maximum of 50 bar slimline design, ideally suited to narrow interference contours
max. speed 8000 rpm in combination with HSK63-HSK100/ISO40 ISO50
A 0,01 B
L Ø
A A-A B Ø 0,01 A
3°
Ident. No. 701–703 D d1 d2 d3
Ø 2,35 G
Ident. No. 700
G D (mm) A (mm) L (mm) d1 (mm) d2 (mm) d3 (mm) 23431...
Ident. No.
M12 25 192 250 12.5 21 24.8 700 ○
M12 25 242 300 12.5 21 24.8 701 ○
M16 32 188 250 17 29 31.8 702 ○
M16 32 238 300 17 29 31.8 703 ○
Prod. Gr. 278
pull stud for steep taper DIN 69872 shape A (DIN 69872)
steep taper to DIN 69871 with bore for IK
IK
Application: Case-hardened HRC 58 ± 2
for tools with steep taper in accordance with ISO 7388-1 (old standard was DIN Soft, bronzed and ground thread and bore hole
69871) and ISO 7388-2 (old standard was JIS B 6339 MAS-BT) Pull studs with o-ring = sealed
Execution: Notes:
All pull studs made from material 16Mn Cr5 Further versions available on request (specification of machine types required)
L
L1
15°
d1 d2 d5 D
No. 23690 No. 23692
DIN 69872, without IC
DIN 69872 69872
Suitable Form d1 (mm) d2 (mm) D (mm) d5 L (mm) Coolant α/ A L1 (mm) 23690... 23692...
for tool supply (Degree) Ident. No. Ident. No.
holding
device
SK 30 A 13 9 13 M12 44 Yes 15 24 130 ● - -
SK 40 A 19 14 17 M16 54 Yes 15 26 140 ● - -
SK 50 A 28 21 25 M24 74 Yes 15 34 150 ● - -
SK 30 B 13 9 13 M12 44 No 15 24 - - 130 ●
SK 40 B 19 14 17 M16 54 No 15 26 - - 140 ●
SK 50 B 28 21 25 M24 74 No 15 34 - - 150 ●
Prod. Gr. 263
Source: Hahn+Kolb Werkzeuge GmbH
732 Technical data subject to change. www.iconridge.com
Availability subject to country specific rules and regulations.