Page 15 - 02-11-2020_2

01 | PAINT PREPARATION & APPLICATION 01
Spray guns

SPG 80

SPG 100 SPG 500

SPG 82 SPG 81

MINI SPRAY GUN SPRAY GUN 10 L PRESSURE TANK
SPG 100 SPG 500 SPG 80

• Ergonomic grip • Ergonomic grip. • The combination of the 10L tank and 10m air/paint tubes makes
• Minimal overspray, maximum transfer efficiency • Minimal overspray, maximum transfer efficiency. the SPG 80 the ultimate tool to protect your spray booth by
• LVLP technology: over 74% effective transfer efficiency • LVLP technology: over 74% effective transfer efficiency. applying cabin protect.
• Lightweight anodized aluminium body • Lightweight anodized aluminium body, available separately: • Includes a set of hoses (black and transparant) and a spray gun
• Can be used for water-based and solvent-based paints stainless steel needle set. with a 1.8mm nozzle set.
• Required air feed pressure: 1.5 bar • Can be used for water-based and solvent-based paints. • Place SPG 80 in the centre of the spray booth, no need to move
• Standard with a 0.8mm nozzle. Nozzles 0.8mm, 1.0mm, • Required airfeed pressure: between 1.8 and 2.2 bar. as the 10m hose will allow you to go around the complete spray
1.1mm, 1.2mm also available separately • Incl. cup 500 ml (also available as spare part SPG 500C). booth without having to move the tank.
• Incl. cup 100 ml (also available as spare part SPG 100C) • Nozzle set to be puchased seperately (not included). • Combination of an aluminium spray gun and a galvanized
powder coated tank allows you to apply in a very comfortable
way any primer, basecoat or topcoat, water or solvent based
coatings.
• Available as spare parts: SPG 83 transparant hose, SPG 82 set of
hoses, SPG 81 spray gun for pressure tank

4 steps to operate the pressure tank (some pressure loss can occur when using a 10m
hose):
1. Pour the product to be sprayed in the tank and set up for use.
2. Close the air inlet regulator on the spray gun completely.
3. Open the trigger of the spray gun and adjust the tank pressure till a smooth +/-15cm
radius product flow is produced.
4. Adjust the air inlet regulator of the spray gun till the desired spray pattern is obtained.

17