Page 88 - KENWOOD Combined Sell Sheets 100119
P. 88
KNA-SPM100
Speed Pulse Generator
FAQ & Troubleshooting
LED Diagnostics
FAQ
◊ LED Blinks RED Indefinitely
» KNA-SPM100 did not receive a How can I verify if a vehicle is compatible?
response from the vehicle.
- This means that the KNA-SPM100 » Verify that the vehicle’s year of
is not compatible with that vehicle. production is 2008+ and has an OBD-II plug.
» CAN wires are disconnected. » The KNA-SPM100 will not work If the
- Verify CAN wire connections. vehicle doesn’t allow a scan tool to be
◊ LED Blinks RED/GREEN During that plugged into it while the vehicle is turned
Ignition Cycle on and/or while driving. Vehicle’s that
» KNA-SPM100 has detected another may exhibit this symptom typically include
OBD-II device, MRR, or another high-end European models.
radio replacement interface module » Ultimately, the only other way to verify if
communicating on the bus. the KNA-SPM100 is compatible is to connect
- The KNA-SPM100 cannot be it to a vehicle and verify the LED sequence.
used in conjunction with another OBD-II » If you have verified an imcompatible
device or MRR (please refer to the MRR or vehicle, please contact us at 1-800-843-6124
radio replacement interface instructions to help in creating a database.
for vehicle speed pulse connection).
Receiver Messages
If you are still receiving a message like
this when attempting to use Wireless
Apple CarPlay while the vehicle is in
motion:
- The receiver is not receiving a proper
and/or any vehicle speed information.
- The GPS antenna is not connected
or an incorrect GPS antenna is being used.
Created by the KENWOOD Training Department - White Papers Available @ KENWOOD University - https://kwu.us.jvckenwood.com
JVCKENWOOD USA Corporation follows a policy of continuous advancement in technical development. For this reason, information contained here and specifications may change.
