Page 10 - Sanbot Max

Basic operation
1.
2.
Transport Sanbot Max Pro
At least 3 staffs are required to transport Sanbot Max Pro at the same time, and the liftable part is the handle of chassis (the specific position please referred to “know about Sanbot Max Pro”--Bottom) and force is forbidden in other parts.
Turn on Sanbot Max Pro
Before turning on Sanbot Max Pro, please make sure that: Sanbot Max Pro is on a flat level ground;
There are no any other obstacles within 90 centimeters of Sanbot Max Pro;
Press the power switch at bottom of robot to turn on the power supply (The specific position
please referred to “Know about Sanbot Max Pro”--bottom).
The first time turning on robot, please follow the instruction on the screen panel to finish start
wizard.
3. Charging method Method1: Auto-charging
Please connect the power adapter of charging pile to power socket and make sure that Sanbot Max Pro’s auto-charging function is enable. During the use of robot, when the power is lower than the set value, Sanbot Max Pro will automatically remind the need for charging. User also can turn on charging mode by voice command or system control.
Method2:Manual charging
Please connect the power adapter of charging pile to power socket and move the robot to
make the charging metal sheet on the back of robot contact metal charging sheet of charging pile. It’s ok when you see the indicator flash on the charging pile or the charging status shows on the robot screen.
Method3: Charging by power adapter
Please remove the back cover screw of charging pile with screwdriver (the specific position please referred to “know about Sanbot Max Pro”- back of charging pile) and open back cover to remove the screw of power adapter (the specific position please refer to “know about your Sanbot Max Pro” – inner of charging pile), then loosen the screw nut of the power adapter charging port.