Page 7 - HAMMER HEAT-SHIELD

HAMMER HEAT-SHIELD HAMMER HEAT-SHIELD

Plywood & Laminate surfaces should be free of dust, wax and Once the tack is formed & the film turns transparent, paste

stickers. Preferably the surfaces to be glued, should be sanded the surfaces properly. Bring the laminate in contact to

and cleaned with cloth. HAMMER HEAT-SHIELD coated ply surface and make
proper alignment.

Stir the contents of the glue container just before application

& spread the glue uniformly with a plastic notch spreader, Apply strong & uniform pressure AND press the laminated

first on the laminate (non porous surface) & then on plywood portion by using wet squeezed cloth or wooden batten or

(porous surface). roller to remove air entraption. Sanding work can start

after 30 minutes but final bonding is achieved after 24 hrs.

Give enough open time (10–15 minutes) depending on

climatic conditions. Ensure touch dry condition before

pasting laminate. Take care of alignment as there is no

scope of re-alignment once fixed. Always use a wooden

log between 2 surfaces for better alignment.

General Instructions & Precautions for Uses:

Put a wooden log between the surfaces for Store awy from direct heat and sunlight

better alignment and start pasting it from Skin Formation, If any should be removed before use

one direction. Take laminate of little bigger Stir the content of the container well before use

size (1.5 mm to 2 mm) than ply so that it Water should not be added for dilution as it

can be trimmed after pasting. may adversely affect the performance of the

product