Page 907 - 2006 HARLEY FLSTCI SERVICE MANUAL

3.29 s0261x3x

2
3
2 1 4

Crankshaft (roller) bearing Chain guide screen and O-ring Figure 3-162. Right Crankshaft (Roller) Bearing Support tube (2) REMOVAL end up Figure 3-163. Right Crankshaft (Roller) Bearing Removal

4 Right crankcase half Crankshaft bearing bore Support tube Curved edges

s0178a3x 3 1 1. 2. 3. 4. Pilot/driver 1. 2. Ram 3. 4. 1

TOP END OVERHAUL: 3.16 3.18 BOTTOM END OVER- SPECIALTY TOOL REMOVAL/INSTALL pilot/driver REMOVAL/INSTALL support tube Obtain CRANKSHAFT BEARING REMOVAL/INSTALL PILOT/DRIVER (Part No. HD- 44065-1) and CRANKSHAFT BEARING REMOVAL/ Place support tube (2) on hydraulic press table with the REMOVAL end up. Note that the sides of the support With the inboard side of the right crankcase half facing upward, position crankshaft bearing bore over support tube. During removal it is important that the curved edges on the pilot/driver (1) match the curved edges of Slide pilot/driver (1) through bearing into support tube. Center pilot/driver u

CRANKCASE REMOVAL OVERVIEW Perform all steps under DISASSEMBLY. Perform all steps under HAUL: DISASSEMBLY. RIGHT CRANKCASE HALF Chain Guide Screen See Figure 3-162. Remove, clean and reinstall screen (3). Replace screen O-ring with each removal. Crankshaft Bearing PART NO. Crankshaft bearing Crankshaft bearing 1WARNING 1WARNING Never move or lift the crankcase by grasping the cylinder studs. The crankcase is too heavy to be carried in this manner and could be dropped. Dropping the crankcase will result in parts damage and could result in death or Figure 3-163. INSTALL SUPPORT TUBE (Part No. HD-44065-4). tube are stamped to ensure

HOME 1. 2. REMOVAL HD-44065-1 HD-44065-4 serious injury. See 1. 2. 3. 4. 5. 6. 3-120