Page 50 - Kim Hong Tee - Design Booklet Year 3

Container Swatch

Introduction Solidworks Modelling Printing

This is a cross project between prototyping

module and 3D modelling module.

First, will be creating a container under several

condition, the main learning outcome here is to
get the tolerance right.

After printing the container, we will then need to
apply our current swatches onto the container

A container under the several condition are Using a software to prepare the printing, It

relatively easy to make, but as being me, I want was relatively easy to set up with the guidance
it to look special and interesting so I settle for a of faculties, such as setting up footing and

whistle inspire by a ocarina. scaffolding.

My tolerance is 0.4mm, 0.2mm on each side the After the print is done, cleaning was nerve

male and the female. wrecking as I do not want to break anything,
but sanding the piece was brutal as my form is

complex, I put in alot of anger into it and lastly I
did a wet sanding to smoothen everything out.

47