Page 274 - JGS4x4 CATALOGUE

> Miscellaneous

X-Defend Pedal Lock

DA6601 DA6601 Right hand drive
DA6602 Left hand drive
Defender - up to Td5 without air-con
The X-Defend Pedal Lock prevents the clutch, brake and throttle pedal from being operated, making a vehicle almost
impossible to drive! Unlike other pedal locks, this remains bolted to the floor of the vehicle. When not in use, it folds
flat on the floor and seat box, forming the floor of the cab. In this position it can be covered with your usual floor mat.
This means you don’t have to store a 20kg lump of metal which could be lethal if it hit you in the event of an accident
or while off-roading. It also means that locking is incredibly quick. Just release the catch which holds it against the seat
box and lock into position. A 10mm thick steel claw grabs the brake pedal shaft and ratchets in tight against it. It can
be locked in a couple of seconds! To unlock turn the key which releases the pedal and fold flat on the floor. The Pedal
Lock is supplied in tough, corrosion proof 304 stainless steel and uses formed hinges with a 6mm stainless pin. It is
supplied with an anti-drill, British made Lowe & Fletcher RPT Lock. Notes - This does NOT fit Series/Defender - 2007
onwards. As not all Defenders are the same and build tolerances are at best acceptable it may be necessary to either
relocate the bonnet pull bracket (you can drill out the spot welds and re-attach with pop rivets) or better still replace with
the later Td5 type bonnet pull (FSC000050PMA). We have discovered that because Land Rover had no set place to fit
the early type bracket it sometimes fouls the pedal lock.
DA1399
Door Hinge Guards
DA1399 4-door kit
The Bombproof Hinge Guard is built to exact specification
and was developed to fit all Defender models and years.
It has been engineered for maximum protection and
ease of fitment. Each Hinge Guard kit consists of two
CAD engineered stainless steel plates which fit inside of
each hinge point, restricting outward movement of the
door with the bulkhead bolts removed. Fitting the Hinge
Guards is incredibly easy with comprehensive fitting
instructions supplied. Each door kit can be easily fitted in
20-30 minutes. After installation, only the top of each plate
can be seen, providing an unobtrusive modification and
deterrent to would-be thieves.
EXCLUSIVE Features DA1412 Defender door fitting kit.
> Notched upper guard - fits neatly around the dash
to Britpart! padding without compromising security. Ideal to keep handy if
> Custom folds - each plate has a carefully measured, removing the door cards
very small offset to allow it to close around the door at any time. Front or rear
frame without tearing the door seal. single door.
> High-Grade 304 Stainless Steel - 2mm thick: thin 2 x Lokut-nut
See them in action at enough to fit unobtrusively, more than thick enough to 12 x Fasteners
www.britpart.com/bombproof protect your hinges. DA1411 Grey kit
> Individually profiled - lower and rear hinges profiled for DA1412 Black kit
Radiator Muffs a perfect fit across all variants. DA4649 Black kit with
clips & snapsacs
DA4025BLACK DA2160BLACK DA2161BLACK

DA2157 DA2163 DA2162

DA2153 Series 2 Defender Discovery
Series 2A - Early Models DA2161BLACK Black edging Black edging
DA4025BLACK Black edging DA2161BLUE Blue edging DA2153 Discovery 1 - up to LA
DA4025BLUE Blue edging DA2161GREEN Green edging DA2157 Discovery 1 - MA onwards
DA4025GREEN Green edging Discovery 2
DA2163
Series 2A - Late Models - square headlights
Series 3 DA2162 Discovery 2
DA2160BLACK Black edging - round headlights
DA2160BLUE Blue edging
DA2160GREEN Green edging
Control the flow of air into your radiator with
Note - The radiator muffs are black
with either black, blue, brown or a quality British made radiator muff!
green coloured edging.
278 www.britpart.com