Page 62 - i-Pilot Link Owner's Manual

HEADING SENSOR

2 c. Double check the position of the Heading Sensor
so that the arrow on the cover is pointed toward the Screw Arrow
Holes
front of the boat in the direction of travel. The arrow to Front
needs to be parallel with the keel of the boat. Keel of
Boat
CAUTION

Failure to align the Heading Sensor correctly will result in Mounting
incorrect compass readings. Location
without Power
Access Cable

Parallel
Placement

3 d. Mark the location of the two screw holes with an awl
or similar marking tool. Heading Sensor
Placement
Marked
e. Move the Heading Sensor to the side and drill two Location
holes using a 9/64” drill bit on the marked locations. of Screw
Holes

4
ITEM(S) NEEDED
#1 x 2

f. Position the Heading Sensor back in place so that 4f
the holes drilled in the mounting location line up Screw Arrow
with the holes in the Heading Sensor. Be sure to Holes to Front
mount the arrow towards the front of the boat and make Keel of
the alignment parallel with the keel of the boat. Boat

g. Apply a marine-grade silicone caulk or sealant to
both #8 - 18x1-1/2 screws (Item #1) as needed to
protect your boat from water damage. Mounting
Location
without Power
CAUTION Access Cable
Parallel
Failure to align the Heading Sensor correctly will result in Placement
incorrect compass readings.

62 | minnkotamotors.com ©2019 Johnson Outdoors Marine Electronics, Inc.