Page 48 - OnlineCatalog v1_8
P. 48

PAGE 48
                                              Anvil Covers




                                   REPLACEMENT AND ROTATION






        ANVIL COVER REPLACEMENT


        SAFETY FIRST!

        Tools Suggested:  Pry Bar and 52 or 64 oz Dead Blow Mallet

        NOTE: New Anvil Covers can be mounted in either direction
               with the FATTER END SECURED FIRST
                                                                                            2. INTERLOCK REMAINING END
        1. Remove Die Board and store in a safe place              1. FATTER END
                                                                   PLACE  IN SLOT FIRST!
        2. Remove and inspect old cover for any issues
                                                                   TAP WITH MALLET
        3. Wrap new cover around the cylinder                      TO SECURE IN SLOT
        4. Put the FATTER INTERLOCKING END INTO THE SLOT and TAP with mallet to secure
        5. Position the other end of the cover so that it interlocks with the secured end.
           TAP into place

        Best practice - REPLACE ALL ANVILS at the same time!                               3. TAP INTO PLACE WITH MALLET








        ANVIL COVER ROTATION
        (Please NOTE: The following Anvil Rotation procedure is NOT for Equalizer Systems)
        SAFETY FIRST!

                                                          PRYBAR IN SLOT ONLY!
        Tools suggested: Pry Bar and 52 - 64 oz. Dead Blow Mallet  PREVENT DAMAGE TO YOUR ANVIL COVERS!

        NOTE: Anvil Covers can be mounted in either direction
                      with the FATTER END SECURED FIRST
                                                                                         REMOVE 1-4

        1. Remove Die Board and store in a safe place

        2. Remove Covers 1 - 4 by using the proper PRY BAR IN THE SLOT ONLY to pry them apart. Inspect for any issues.
                                                                                                     LOOSEN AND SHIFT 5 - 8
                                                                                                     TAP INTO PLACE
        3. Loosen Covers 5 - 8. Shift and drape in new position.  Secure Covers by TAPPING into place with the Dead Blow Mallet


        4. Reattach Covers 1-4 into new position as shown


        REGULAR ROTATION makes your Anvils Last Longer!                                               REATTACH 1 - 4
                                                                                                      TAP INTO PLACE

        48
   43   44   45   46   47   48   49   50   51   52   53