Page 72 - The Complete Rigger’s Apprentice
P. 72

Figure 3-1. Belaying with a Clove Hitch backed up by
             a Rolling Hitch.
                                                          Figure 3-2. A belay to a horn cleat starts with a full
                                                          turn around the base (A) and ends with a Half Hitch
             keep in mind are: Control, Security, Ease of Casting
             Off, and Ability to Surge.                   (B). Avoid turning the finished loop in the wrong
                To illustrate, let’s look again at those tent guys.   direction (C). Note that the cleat is angled to the
             The Clove Hitch creates friction, so that only a frac-  lead of the standing part. Note that, with a slicker
             tion of the strain comes on the rope end, and it’s   line and/or cleat, more figure-eight turns might be
             easier to control the load while making the Rolling   needed, to prevent the line from slipping, and to pre-
             Hitch, which provides security and a means to take   vent the locking hitch from jamming.
             up slack when the line is tightened. This hitch never
             jams, so the tent will be easy to strike. And the fric-
             tion of the Clove Hitch makes surging (gradually
             paying out slack to a line under strain) an easy and
             safe operation.
                All of this is even easier on a cleat, that most
             highly evolved belaying tool. In Figure 3-2, the line
             takes a turn for control around the base of the cleat
             before beginning the two or three figure-eight turns
             that provide security. Note that the cleat is angled
             away from the lead of the line. This makes it easier
             to get a turn started, prevents the line from jamming
             against its own standing part, and more evenly dis-
             tributes the strain on the bolts that hold the cleat
             to the deck. When making fast to a bollard (Figure
             3-3), take a turn first around the nearer post before
             commencing figure-eight turns around both. This
             minimizes the tendency of the farther post to “lever
             up” under extreme loads.                    Figure 3-3. The first turn on a bollard in line with the
                To keep the turns of a belay from coming loose,   lead should be around the near post (A). When the
             make a Half Hitch to finish. Just pretend you’re   lead is perpendicular to the bollard (B) either post
             going to make another figure-eight, then slip a     will do.
             loop under the line and over the horn of the cleat

                                                                                                       51
   67   68   69   70   71   72   73   74   75   76   77