Page 93 - Regal ideas Binder_USA_2020

urbanrail ® Installation Instructions

Gate Installation (URGP)

(Gate is designed to fit an opening of up to 36” )

Max 36”

Gate kit includes one pair of Gate assembly requires ¾” Gate is designed to fit an Place welded bracket of top
hinges, pickets and spacers, self-drilling screws (URCS50 opening of up to 36” and the rail under post cap.
hinge post, latch post, strike sold separately) width may be cut to fit.
latch, and top & bottom rails For opening smaller than Top of bracket should
with welded flanges on one 36”, subtract 6” from the be touching the under-
end. clear opening distance (i.e. side of the post cap.
34” opening – 6” = 28” rails).
This is the length to cut the
rails.

34”

TIP: Pre-drill using 1/8” Attach the welded bracket Measure from underside of Repeat steps and attach
(3mm) drill bit. to the post using a URCS50 top rail welded bracket 34”. bottom rail to post.
screw (sold separately). This will be the position of
the top of the bottom rail
bracket.

Next step is to attach the Pre-dirll on the underside of Repeat step for bottom rail. Drill holes every 16” - 24” in/
post with the welded brack- the welded top post bracket, through the bottom rail for
ets to the top and bottom through the top rail. water drainage, using a 3/8”
rails. diameter drill bit.
Fasten the post to th rails
using the URCS50 screws
(sold separately)

regalideas.com/urbanrail | Toll Free: 1-800-819-4344 | Fax: 1-604-952-4291 | email: sales@regalideas.com 9
V2