Page 78 - Regal ideas Binder_USA_v3

Secondary Handrail
ADA Compliant Handrail

Before you begin installing any section, please take the time to plan and layout your section to
ensure you have calculated the proper length and have all the necessary parts to complete, including
the correct fasteners.

It is Important to check with your local building codes for guidelines and limitations before installation.

INSTALLATION GUIDELINES: 3. Ensure rail ends are pushed tightly into the HAC until
you see the aluminum rail end completely cover the
inside screw hole of the HAC.
Rail Splice/Connector Model: HSC 4. Use a 1/8” (3mm) drill bit to pre-drill the 2 screw holes.
Use to connect handrail end to elbows, corners and loop return. 5. Secure rail ends into HAC by using a #2 square head
screwdriver and the screws included.

90° Wall/Post Return Model: HW90
Use to start or end your handrail/ stair rail against a wall or post.

1
3 2

1
3

For use with HR08/ HE5/ HE35/ HLR/ HCR
1. Slide rail splice/connector into rail end until metal tip in 2
center of rail splice/connector touches the rail end.
2. Slide collar ring over open end of rail splice/connector 1. Push collar over HW90 wall/post return, until inside ring stops
until it connects with the metal tip in the center of the at center lip.
rail splice/connector and covers part of the rail end. 2. Push rail end firmly onto/toward HW90 until rail end touches
3. Slide second rail end over opposite end of rail splice/ inside center ring of collar and collar has no lateral movement.
connector. Push together both rail ends until they are
IMPORTANT: Ensure top of handrail is set at proper
both touching the inside inner ring of the collar and there height/level before drilling into wall or post.
is no lateral movement of the collar ring. 3. Mark screw holes onto wall or post and use the appropriate
Do not cut the HSC splice/connector. Cut the rail drill bit size to pre-drill into surface.
ends if you need to adjust railing length.
Make sure you use the appropriate fasteners for the surface
Adjustable Angle Connector Model: HAC you are attaching to. For mounting into Regal ideas aluminum
Use to create custom angles. posts, use Regal ideas Ceramic Screws (WCS-50-TS)

Fasteners Guide for HW90
Surface Screw Size Qty Drill Bit Size
2
Aluminum #10 x 3/4” 4 1/8” (3mm)
#10-14 x 1”
1 4 3 Brick/Concrete (Screw with 4 5/16” (8mm)
Anchor)
Wood #10 x 2 1/2” 4 not required
5

Under side The above is a guide for reference purposes. Fastener type and length
will vary depending on the surface and material you are mounting into.
1. Connect Rail end into one side of HAC.
2. Connect second rail end into opposite side of HAC. 3
regalideas.com ADA
COMPLIANT