Page 19 - E-MODUL CAM CNC MILLING_E-MODUL 1
P. 19

Gambar 4.24. Right (conventional milling) .............................................  158

                Gambar 4.25. With Finishing passes .....................................................  158

                                                                  ...............................................
                Gambar 4.26. Without Finishing passes                                                159
                Gambar 4.27. Number of finishing passes Enabled                ..............................  159
                                                                               .............................
                Gambar 4.28. Number of finishing passes Disabled                                     160
                Gambar 4.29. No finishing overlap .........................................................  160


                Gambar 4.30. 0.25" finishing overlap ..................................................... 161
                Gambar 4.31.No finishing overlap ..........................................................  162

                Gambar 4.32. 0.25" finishing overlap .....................................................  163

                Gambar 4.33. Ilustrasi Penerapan Both ways .......................................   164
                Gambar 4.34.Tampilan penerapan Maximum stepover........................              165

                Gambar 4.35. Adaptive clearing.............................................................  165

                Gambar 4.36. Legacy 2D clearing..........................................................  166

                Gambar 4.37. With Minimum cutting radius set ....................................    166

                Gambar 4.38. Without Minimum cutting radius set              ...............................  167
                Gambar 4.39. Standard 2D pocket toolpath ..........................................  168

                Gambar 4.40.Morphed spiral 2D pocket toolpath .................................      168


                Gambar 4.41. Allow stepover cusps disabled              .......................................  169

                Gambar 4.42. Allow stepover cusps enabled              .......................................  169
                Gambar 4.43. With Multiple Depth cuts           .................................................  171
                                                                    ............................................
                Gambar 4.44. Without Multiple Depth cuts                                             171
                Gambar 4.45. Shown with three finishing passes.................................      173


                Gambar 4.46. Finishing stepdown           .........................................................  173
                Gambar 4.47. Slope angle @ 0 degrees ................................................  174

                Gambar 4.48. Slope angle @ 45 degrees ............................................   175
                Gambar 4.49. Geometry Bottom Selection ...........................................   175

                Gambar 4.50. Top Selection ..................................................................  176









            xix
   14   15   16   17   18   19   20   21   22   23   24