Page 299 - MMS Jim Humbl's Heart Mind Healing
P. 299
280 MMS Health Recovery Guidebook
q Count two seconds using the “one one-thousand, two
one-thousand” method, then remove the strip from
the liquid. (Do not flick any of the liquid off the strip
when you take it out.) Do a similar count up to ten and
then check the color on the strip with the color chart
on the side of the LaMotte container. When you use 3
MMS1 drops in 4 ounces/120 ml of liquid, your number
as indicated by the color on the strip, should be
between 25 and 50.
Step 3
q Cover and set aside your liquid (out of the light) with
the 3 drops of MMS1 and wait one hour.
Step 4
q After one hour, do the same test over again with the
same liquid, but with a new test strip. The number
indicated by the color on the strip as compared to the
color chart should again be between 25 and 50, and if
it is, your liquid is compatible with MMS1.
q If the reading on the strip goes down after one hour,
this means in an hour the MMS in the liquid has lost
some potency. If it hasn’t gone down too much, (the
strip should not read less than about 20 when
compared to the color chart), you could still use that
type of liquid providing every time you drink your dose,
you take it immediately after putting the MMS1 in. (As
a rule, you should always take your MMS1 dose within
a minute of mixing it up.)
Notes
It is important to keep the bottle of your test strips
tightly capped at all times when not in use. This will keep
moisture out, which can affect the readings.