Page 43 - QR PENTRUDER 3P8

Operators Manual - High Frequency driven Pentruder 3P8 Wire Saw

• Do not set the rollers too hard. If set to hard, the result will be premature wear of the
column. Hold the eccentric shafts with a 1/2 “ tool and tighten lock bolts with a 15 mm
wrench. With correct preload on the rollers the carriage will run smoothly and give a
very rigid support for the wire saw modules.

How to replace the cog belt

Disassembly
1. Remove the center bolt holding the pulley. 14 mm allen key.
2. Remove bearing cap and seal.
3. Remove all M6 bolts holding belt cover to back cover. 5 mm allen key.
4. Remove the belt tensioning bolt. 6 mm allen key.
5. Losen the bolts holding pulley shaft. 8 mm or 5/16” alllen key
6. Lift main drive pulley and slide it off the pulley shaft while holding back the cog belt

Assembly

1. Put a new belt on the small cog wheel.
2. Slide the main drive pulley on to the pulley shaft while at the same lifting the pulley and

putting the belt over the big cog wheel pulley.
3. Push the pulley inwards while at the same time turning it to make the belt line up.
4. Tighten the pulley shaft bolts slightly.
5. Tighten the belt tensioning bolt firmly.
6. Tighten the pulley shaft bolts firmly. (60 Nm)
7. Fit and tighten bolts holding rear cover to belt cover.

Fig. 33 Main drive pulley

Pentruder® - Stronger than ever! Tractive AB 17 March 2009 Page 41
Applying Standards That Are Years Ahead Of the Competition.