Page 56 - TEESIN E-CATALOG 200219EN VER2

LECTRIC
EVIBRATOR

MVSI-E
Italvibras MVSI-E electric vibrators has been designed for use in industrial
processes in environments with a potentially explosive atmosphere, due
to the presence of explosive gas and dust, in compliance with ATEX
Directive(94/9/EC).
POWER SUPPLY
Three-phase voltage from 220v to 690v, 50Hz or 60Hz: suitable for use with a PWM
MVSI-E frequency drive from 20 Hz to the base frequency with constant torque load profile.
MVSI-TS
Italvibras MVSI-TS electric vibrators, obtained directly from the MVSI se-
ries are characterized by the split weight covers. According to requirement
it is possible to mount one or two split weight covers. The MVSI-TS series
is indispensable in those application where the position of the vibrator in
the vibrating machine makes it diffult to axially remove the weight cover,
while it has space to carry this out in a radial direction.
POWER SUPPLY
MVSI-TS Three-phase voltage from 220v to 690v, 50Hz or 60Hz: suitable for use with a PWM
frequency drive from 20 Hz to the base frequency with constant torque load profile.
MVCC
The Italvibras MVCC electric vibrators with direct current have been
designed for use in those situations where network electricity in not
present. In particular for hoppers silos and gate-control and roll-on-roll-off
vehicles (concrete mixers, pumps of concrete, plasterers, salt distributors,
gravel spreader, fertillser spreader, hauled silos, industrial sweeper filter).
The newly conceived electric motor, with permanent magnet poles and
the increases in size of the electric parts, allow constant, high yielding
performance.
POWER SUPPLY
MVCC In direct current at 12 or 14V
MVSI-ACC
Italvibras MVSI-ACC electric vibrators, deriving directly from the MVSI
series, are characterised by the motor shaft projecting from one side or
from both sides, allowing in-line coupling, using a coupling, between
two or even are equal vibrators. The MVSI-ACC series is very useful
of manufactures of large screens and vibrating machines, or for plants
that require very high centrifugal force values. With two vibrators of the
MVSI-ACC series coupled in line, it is possible to arrive at centrifugal force
of 61000Kgf(600KN).
POWER SUPPLY
MVSI-ACC Three-phase voltage from 220v to 690v, 50Hz or 60Hz: suitable for use with a PWM
frequency drive from 20 Hz to the base frequency with constant torque load profile.
page 56