Page 34 - PPW E-CATALOG280419

PPW-POLYPLAN-WERKZEUGE GMBH

The most individual way to

coating height

PPW Coating trowel (288) <

By using tooth trowels different coating heights can be applicated, however they always depend on the form of the
tooth blade and the angle, how the tooth blade will be hold. If the tooth trowel will be hold more oblique, the
passage will be reduced through the tooth blade and the required height of coating cannot achieved anymore.
The heigth of cold bitumen- or liquid plastic coating by using the PPW coating trowel (288) will be appropriated
through the diameter of the discs, which will be delivered with a jagged border*.
Unimportant is the angle in which the PPW coating trowel will be hold to the ground, the distance is always the
same and so a continual height of coating is guaranteed. Even on treads or sills the position of the coating trowel
don't has an effect on the height of coating. The filmy rubber lip is closing the fine tracks in the coating
immediately without affecting the height of coating.

*The discs are minimal bigger as the wanted coating height.
As long as the jags are not worn, the coating height can be ensured. (fig. above)

The blade of the PPW coating trowel (288) will be delivered complete with 5 discs and protection strip - but
without handle. Because it is possible to equip the blade with a wodden handle or a plastic-soft-handle, on
demand mounted for lefthanded- or righthanded persons.

Coating trowel (288-**) complete with wooden grip (288 H)
and protection strip

PAGE 34