Page 53 - M1-12 Ops Manual McMurdo 2016

APPENDIX A
DEFAULT PARAMETERS
procedure is complete and the instrument reverts to the “Normal Display Mode.” The following is a list of the default operating parameters loaded during the procedure:
DEFAULT PARAMETERS
Loading Default Operating Parameters
Default Operating Parameters List
The control parameters can be loaded with predetermined default values. These are the settings loaded into the instrument prior to shipment from the factory. To load the default values proceed as follows:
Parameter
Alarm Acknowledge Software Key Setpoint Threshold
Default Value
OFF
Unlock
Low range value (if low limit) High range value (if high or high/low limit)
a) Press and hold the key and press the key; the displays will show:
Setpoint1 Threshold Setpoint Threshold
Low range value
b) Press either the or show:
key; the display will
c) Press the "FUNC" key; the display will show:
This indicates that the loading procedure has been initiated. After about 3 seconds the loading
Appendix A.1
Hysteresis Alarm Threshold
0.1% Lowrange(ifprocessalarm) 100 (if deviation or band alarm)
0.1%
Alarm Hysteresis