Page 54 - M1-12 Ops Manual McMurdo 2016

Loading Default Configuration Parameters
The configuration parameters can be loaded with predetermined default values. These are the settings loaded into the instrument prior to shipment from the factory. To load the default values proceed as follows:
f) Press the FUNC key; the display will show:
a) Internal switch V101 must be open.
b) The upper display will show:
c) Press the key; the lower display will show the firmware version.
This indicates that the loading procedure has been initiated. After about 3 seconds the procedure is complete and the instrument reverts to the “COnF” display. The following is a list of the default configuration parameters loaded during the procedure:
d) Still holding the key, press the key; the display will show:
e) Press the key to select Table 1 (Euro- pean) or Table 2 (American) default parameters; the display will show:
Appendix A.2