Page 4 - Microsoft Word - ASEPT-UV User Manual
P. 4
1. Initialization
1.1 Installation of charger
Install the robot charger (shown below) in a suitable position according to the
following requirements:
(1) Check whether there are obstacles within a 1m radius in front of the power
supply on the wall, and whether the ground is flat. Remove obstacles if any, or use
this product in an obstacle-free flat area.
(2) The charger should be installed against the wall and kept stable without shaking
when pushed.
(3) When the power adapter is connected to the charger and mains power, the
charger will be in the charging state.
(4) The indicator of the power adapter is red when the robot is charging and green
after charging is finished.
1.2 Robot ON/OFF
1.2.1 Emergency stop button
Press the red “Emergency stop button” (as shown in the figure below) at the bottom
of the robot to stop the robot. In this case, the robot can be pushed to move.
Page 1
