Page 16 - E-MODUL CAM CNC MILLING_1
P. 16

Gambar 3.30. Both ways Unselected .........................................................  88

               Gambar 3.31. Both ways Selected ..............................................................  89

               Gambar 3.32. With Minimum cutting radius set........................................   90

               Gambar 3.33. Without Minimum cutting radius set ..................................     91

               Gambar 3.34. With Multiple Depth cuts ...................................................  93

               Gambar 3.35. Without Multiple Depth cuts ............................................. 93

               Gambar 3.36. Maximum stepdown - Ditampilkan tanpa finishing
               stepdowns ...................................................................................................  94

               Gambar 3.37. Shown with three finishing passes ......................................  95

                Gambar 3.38. Finishing stepdown ............................................................  95

               Gambar 3.39. Slope angle @ 0 degrees .....................................................  96

                Gambar 3.40. Slope angle @ 45 degrees ...................................................  97

                Gambar 3.41. Bottom Selection ................................................................  97

                Gambar 3.42. Top Selection.......................................................................  98

                Gambar 3.43. Finish only at final depth Disabled ....................................  99

                Gambar 3.44. Finish only at final depth Enabled .....................................  99
                Gambar 3.45. Order by depth Disabled ....................................................  101


                Gambar 3.46. Order by depth Enabled ....................................................  101
                Gambar 3.47. Order by island Disabled ...................................................  102

                Gambar 3.48. Order by island Enabled ....................................................  102

                Gambar 3.49. Order by step Disabled ......................................................  103

                Gambar 3.50. Order by step Enabled .......................................................  103

                Gambar 3.51. Sharp Corners .....................................................................  105

                Gambar 3.52. Chamfered Edges ................................................................  105

                Gambar 3.53. Chamfer width added to sharp edge ...................................    106

                Gambar 3.54. Macam bentuk sisi benda ...................................................  107









           xvi
   11   12   13   14   15   16   17   18   19   20   21