Page 104 - 2022-23 Auto Performance Drag Racing

Engine Lift Plates for LS Series GM Engines
Cam Bearing Installation Tool ALL96470
For installing cam bearings quickly and easily without dam- age. Shaft is steel; pilot and driver are aluminum.
LS Main Cap Removal Tool ALL96525
Quickly and easily
pull main bearing
caps off GM LS series
V8 engines, especially
those with main studs.
Hook tool to the bottom of
cap, press down on handles, and the
balanced leverage pulls the cap out of
the block with one swift motion. 26" long x 4" high.
Rod and Piston Holder ALL96478
Holder safely supports piston
and connecting rod assemblies
during engine teardowns or
assembly. Slots are 4-3/4" L x
1-1/2" W to accommodate most combinations. Holder measures 24"
x 12" x 9-1/2" tall and can be disassembled for storage.
Rod Guide Tool ALL96480
Plastic tool slips over
3/8" or 7/16" rod bolts to
aid piston installation and eliminate the chance of rod bolts hitting crank. A must
for any engine builder’s toolbox.
Part No. Description
Related Part
ALL96481 Rod Guide Tool Extensions 4.5", 1-Pair Plastigage® Kit ALL96475
Plastigage strings are a simple and accurate way to verify crankshaft, main and rod bearing clearances. Kit includes two
green .001" to .003" and one red
.002" to .006" (12" long strings),
individually packaged inside cali-
brated sleeves. Detailed instructions are included.
Valve Spring Compressor
ALL96490
Adjustable C-clamp style
compressor will fit most heads
including Hemi. Spring cup
will fit stock springs up to 1.750"
diameter and has a 1.100" “working window” for access to keepers, which may be too large for some small diameter spring/retainer combinations. Compressor has 9/16" hex for use with a wrench, ratchet or impact. This tool will handle spring pressures in excess of 1200 lbs. without slipping off.
Engine plates are designed for lift-
ing LS series GM engines. Installation
of lift plate requires removal of the intake
manifold and valley cover tray to properly se-
cure lift plate to engine block. Plate features three lifting points, allowing engine weight to be balanced or offset. Made from 3/16" thick zinc plated steel.
ALL10140
DRAG RACING
Tools & Pit Equipment
Part No.
Description
ALL10140
LS Gen III Engine Lift Plate
ALL10143
LS Gen IV Engine Lift Plate
ALL10141
LS Gen V Engines
Ford EFI Engine Lift Plate
ALL10125
Ease engine swaps with the Allstar
engine lift plate. Fits standard 5.0L/5.8L EFI intakes: OEM, GT-40, Cobra, Holley, Edelbrock.
Engine Oil Pressure Primer Tank
ALL10535
Primer tank supplies initial oil to the oil pump in engines equipped with a crank-driven oil pump. Fill primer tank with engine oil, then apply compressed air to force the fluid throughout the engine via the oil pressure sender/switch port to pre-lube the entire engine including the oil pump.
Oil Filter Cutter
ALL10538
Tool removes the outer
shell of most spin-on style engine oil filters to inspect the filter material for contami- nation or debris.
Freeze Plug Driver Set ALL96482
Have problems installing freeze plugs? Use these plastic drivers along with a hammer or mallet for simple installation without damag- ing the plugs or the block. Three sizes per set: 1-1/2", 1-5/8", 1-3/4". (Size refers to size of plug)
Part No.
Individual Drivers
Description
ALL96483
1-1/2" Driver
ALL96484
1-5/8" Driver
ALL96485
1-3/4" Driver
102
2022-23