Page 80 - 2022-23 Auto Performance Drag Racing

Fuel Cell Mounting Bracket
ALL60063
Steel bracket is radiused to fit 1-1/2" tubing and has (8) 3/8" holes on 1/2" centers. Bracket is .085" thick and 1-1/2" wide x 4-3/4" tall.
Fuel Cell Cap and Bolt-In Bung Kits
Fuel Cell Mounting Brackets
Steel brackets are .125" thick, 1-3/4" wide and available in three lengths.
All have 3/8" holes.
Part No.
DRAG RACING
Fuel System Components
Description
ALL40136
Hot Rod Ford 9" Housings
ALL60060
2" Long
ALL60061
3" Long
ALL60062
4-3/4" Long
Billet aluminum neck looks good and provides a positive seal. The filler neck is raised to help prevent dirt and debris from falling into cell, causing fuel system contamination, while the large 3" opening helps when refueling. Kit includes mounting hardware.
Part No.
Rear Ends & Axles
Ford 9" Floater Housings
Housings are jig welded for correct alignment using a select used center section, new 3" O.D. x 3/16" wall axle tubes and include gear case mounting studs, fill and drain plugs.
Note: Axles are sold separately.
Description
ALL40134
ALL40133
12-Bolt JAZ/RCI w/Red Cap
ALL40134
6-Bolt JAZ w/Red Cap
ALL40136
12-Bolt JAZ/RCI w/Black Cap
ALL40137
6-Bolt JAZ w/Black Cap
Housing Width/Offset
TECH TIP
Housing Measuring Diagram
(60"*)
(28"*)
Example: Bare housing ALL68702 is 60" from hub face to hub face and the pinion is located 2" to the left of the hous- ing centerline when viewed from rear of housing.*
Notes: Please measure and inspect housing before welding brackets or painting. Housing is non-returnable if modified or custom. Welding suspension brackets on rear end hous- ings can cause warping. Check for straightness after welding. These housings use Allstar ALL72100 inner grease seals.
*Dimensions for example only.
Steel Hot Rod housings are built with all
new components. The pumpkin section
is centered, so the pinion yoke is offset
approximately 1" to the right allowing
for symmetric tube bracketry on each side. Includes vent, pumpkin studs, and bearing retainer t-bolts. Tube diameter is 3" with 3/16" wall thickness and features large bearing late/ Torino-style ends. Axles sold separately. Width measurements are from axle flange to axle flange.
Part No. Description
Ford 9" Truss Support ALL68330
Weld-on support adds strength to rear axle housing and reduces unwanted flex during extreme torque. Constructed of 12-gauge (.108") steel. 36"L x 2"W.
2.0" Pin
2.5" Pin
58"/Centered
—
ALL68820
60"/Centered
ALL68700
ALL68822
60"/2" Offset
ALL68702
—
62"/Centered
—
ALL68824
63"/2" Offset
ALL68708
—
ALL68830
56"
ALL68832
58"
ALL68834
60"
(32"*)
Top View
Front Of Vehicle
78
2022-23