Page 248 - Foton Workshop Manual - Aumark (BJ1099)

11-22 ENGINE CONTROL SYSTEM - COOLANT TEMPERATURE SENSOR

OVERHAUL

1. Check coolant temperature sensor
(a). Soak temperature sensing part of coolant
temperature sensor to hot water,measure
2
1 3 the resistance between No.1 and No.3
terminal of coolant temperature sensor by
multimeter.
(b). If the measuring result does not conform to
standard, the coolant temperature sensor
shall be replaced.

Ω Measurement Standard
condition resistance(kΩ)

fuwx11008 20℃ 2.1~2.7

100℃ 0.3~0.4
NOTICE:
Put working area of sensor into water, upon
simulating detection, do not let water enter into
binding post. After the checkup, the sensor shall
be wiped dry immediately.
NOTICE:
• Upon checkup, the sensor connector shall be
disconnected, and the resistance at sensor side
shall be detected by multimeter.
• If the checkup does not conform to provision, the
coolant temperature sensor shall be replaced.

Page 248