Page 269 - Foton Workshop Manual - Aumark (BJ1099)

ENGINE MECHANICAL SYSTEM - ENGINE ASSEMBLY 12A-1
ENGINE ASSEMBLY

REPLACEMENT
NOTICE:
• Before disassembling the engine assembly, drain up all the fluids in the engine and
disconnect the harness, pipe fittings and connections between the engine and the body.
• Before disconnecting all harness and pipes, mark them properly to prevent mismatching
or missing harness and pipes during installation.
• Once a fitting is disconnected, seal the opening to avoid foreign objects from entering.
• All drained fluids must be collected and handled as required. Keep the site clean and
neat.
12A
1. Discharge the pressure in the fuel system (Refer to"Chapter 13 Fuel - Fuel System,
Notices")
2. Disconnect the positive and negative battery cables (Refer to"Chapter 18 Starting &
Charging - Battery, Replacement")
3. Drain the engine oil (Refer to"Chapter 04 Vehicle Maintenance - Replacement,
Engine Oil Replacement And Oil Filter (Isf2.8)")
4. Drain the coolant (Refer to"Chapter 04 Vehicle Maintenance-Coolant, Replacement")
5. Collect the refrigerant (Refer to"Chapter 41 Heating & A/C - Refrigerant,
Replacement")
6. Drain up the hydraulic oil in the power steering tank

7. Disconnect the harness connector and the
grounding harness
(a). Disconnect the ECM connector and the
connection between the harness and the
body.

fuwx12A001

Page 269