Page 14 - Foton Workshop Manual - Sauvana

01-8 INTRODUCTION - GENERAL RULES OF MAINTENANCE OPERATION

• When two people or above jointly operate, be sure to pay
attention to the safety of others.

• If performing operation when the engine runs, always make
sure the good ventilation of workshop.
• When operating the high temperature, rotation, movement
3 Safety operation or vibration parts, always wear necessary protective device
to avoid to get burned or damaged.

• When jacking the vehicle, always perform operation in
specified supporting point and make sure the firm support.
• When jacking the vehicle, always use safe and qualified
equipment to perform operation.

• Before performing maintenance operations, always get
Preparation for tools ready tool rack, special tools, measuring instruments,
4
and measuring meter accessories, cleaning cloth and replacement parts used by
vehicle.
• Perform complete analysis and diagnosis for fault symptom,
and take effective solutions
• Before removing parts, check its general situation and
Removal installation and whether there is deformation or damage, etc..
5
disassembly assembly • When parts are very complex, record the operating steps or
make assembly marks to avoid damaging its function.
• Clean the removed parts as required, perform installation
after complete inspection.

• Put the removed parts according to sequence to avoid
being disturbed or contaminated.
• The disposable parts including O-rings and self-locking
6 Removed parts screw
shall obey the guidance of this manual, and new part shall
be replaced after removal.
• Reserve the replaced parts in case the customer checks.

(b). Jacking and supporting the vehicle.
• While jacking and supporting the vehicle, you must be especially careful and
ensure to implement the operation in the correct position. (Refer to "Chapter 01
Introduction - General Rules Of Maintenance Operations, Vehicle Jacking And
Supporting Position")
(c). Glue parts
• Glue parts refer to the parts having being applied with sealant before delivery,
such as bolt, nut, etc.
• If a glue part needs to be loosened, fastened again or moved in any way, it must
be reapplied with the designated sealant.
• When a glue part is reused, be sure to clean up the original sealant, and use the
compressed air to dry it, then apply the designated sealant onto the bolt, nut or
screw thread.

Page 14