Page 36 - Foton Workshop Manual - Sauvana

01-30 INTRODUCTION - HOW TO TROUBLESHOOT THE VEHICLE

•Check visually whether the connector is rusted, mixed with metal debris and dipped by
water, or whether the pin is curved, rusted, mixed with foreign matters or distorted.

Check the contact pressure of pins:

• Insert the male plug prepared into the
female plug to check the coherent state
and sliding resistance.
WARNING:
The gilded male plug must be used to check the
gilded female plug.

(d). Maintenance methods of connector pins.
• If the contact is polluted by oil stain, it
must be cleaned with compressed gas or
duster cloth. Do not polish it with emery
cloth, because the galvanized coating
may be destroyed.
• If the contact pressure is abnormal, the
female plug should be replaced. At this
time, if the male plug is gilded, the gilded
female plug must be replaced; if the male
plug is silver-gilt, the silver-gilt female
plug must be replaced.
(e). Operating notes of harness.
• Before removing the harness, check it
and the position of the harness strip to
make sure the exact reassembly.
• Do not distort, pull and suspend the
harness excessively.
• Do not contact the harness with parts
of high temperature, rotation, move,
vibration and tartness (e.g. panel edge,
screw tip, etc. )
• While installing parts, do not press or
clamp the harness.
• Do not cut or damage the insulation
covering of the harness. If it is broken
carelessly, replace the harness or bind
up the breakage with the empire cloth.

Page 36